Fealix

About

Username
Fealix
Joined
Visits
31
Last Active
Roles
Member
Points
12
Badges
3

Comments

  • https://ieeexplore.ieee.org/abstract/document/1549727/
  • I can get them for very cheap i am not sure their projected in vivo but I do know that it is biocompatable. I will prolly pick up a bunch next paycheck and look for ways to test them.
  • I have heard that you want disk magnets (although they are technically both the same) for finger magnets. a good size seems to be 3mm x 1mm I am probably putting in an order for a bunch in the next month or so.
  • Looking into them today. thank you.
  • Good news: Alright so I have discussed getting some magnets. They told me that they can make them. Bad news: " Dimension Coatings 250 pcs 500 pcs N55 Titanium Nitride $2.00 $1.10 N52 Titanium Nitride $1.95 $1.05 N55 Parylene $6.40 $4.00 N52 Parylene $6.10 $3.80 Fedex Int'l Shipping cost $85.00 $85.00 Lead time: abut 40-45…
  • Appreciate the feedback. I blanked on the malleable nature of the coating. But the n52 or higher is good info. I am a bit new to this all but I am finding myself ahead of my bills lately so I figure i would start looking into this again. I just sent an email to applied magnetics about possible coating options they have. I…
  • Is there any reason these would not work? Of course if their coating is poor but i meant any other reason? https://www.amazingmagnets.com/p-48-d063a-au.aspx
  • sadly all my welding contacts are hand welders. no laser shops I am familiar with. I am currently crowd sourcing to see if anyone knows a shop that might be able to accommodate.
  • im down to prototype. prolly in the 30-45 range as well.