ChilliEye

About

Username
ChilliEye
Joined
Visits
2,802
Last Active
Roles
Member
Points
62
Badges
10

Comments

  • How could i make something like this, I want a standard 3.5mm jack end, so i can put it into devices with that socket, pc for example. 
  • I cant see the images.
  • http://www.tahomaclinicblog.com/lithium-the-misunderstood-mineral-part-1/ "The amounts of lithium I recommend for brain anti-aging range from 10 to 20 milligrams (from lithium aspartate or lithium orotate) daily. I’ve actually been recommending these amounts since the 1970s. At first I was exceptionally cautious and asked…
  • It's a doozy.
  • If aspartic acid stimulates NMDA receptors, this is a better choice than the others? The others seem to be toxic, but not a lot of literature apparently about lithium aspartate. What is meant by serum levels? I'm going to give it a go, 5mg daily as per supplements instructions.
  • What dose are we talking about? Impossible to reach through eating without a doubt. It sounds interesting, these are the only things I can find. Except for science looking pages, and expensive. * Lithium Aspartate * Lithium Orotate * Lithium Chloratum 
  • Have one under your arms, and you may have a glider
  •  Any left up for grabs? I thought this would be miles off and didn't realise everyone had stumped up already. Depends on cost shipped over the pond though really.
    in Ce6 Comment by ChilliEye March 2015
  • Yes, I put two in at the same time, used the chlorhexidine on both for about an hour. Think it was that I knocked it a few times, or just bad luck, and it does say it's not ideal sterilization on the info sheet. The other one is fine though.
  • Well, might not be that then, it was in 3 weeks exactly, and it's still solid. Going to soak it in IsoProp, see if it comes off, will 99.9% be safe to stand in for a while? Or I might just leave it, if it is exposed it will decay soon enough, and there is my answer.
  • Took it out it has some sort of black mark, I'm assuming its a gap in the coating, can't really tell as I have nothing to get a close look at it. Gutted , lost a magnet before, and now this one is useless for implant. :(
  • So, if you drain it once, and you continue to produce pus, just get it out? That is my situation, I'm not even going to wait for any sort of response, it's been like this a few weeks, seemed to be improving then, pus. So I'm taking it out now. If the magnet is out will the infection clear up?
  • Any chance you could video your next needle style implant, Doesn't really need to be voiced over, I'd just like to see it happen clearly.
  • Yes, I also envisaged spot checking over continuous monitoring, which to me suggests the need for built-in display. I think a screen is needed to make it quick to check temperature at any time, if you need to get your phone and load the app, it takes time, admittedly not much, depends if that would bother you. Obviously it…
  • If you had a microphone on one or more of your fingers, and recorded the sound of rubbing various different textured surfaces, and then played it through this coil loop, would the magnet vibrate in a way that made you feel as though you were touching the surface that recorded the sound? It would be interesting if so.
  • I was wondering about how well it would sit in a finger tip too. I only have small fingers. Also, I was wondering about injecting into the lip, would it be viable?