last few check before install
so for anyone following my other thread i have finally received my correct parylene coated magnets from supermagnetman.
just wanna know if what i have here is correct to prepare for the install.
1. throw them in some saline solution for a few days and see if bubbles develop on the surface to verify integrity of the coating.
2. sterilize with (insert here)
3. install?
i wasnt sure if alcohol is sufficient, im guessing ill need something else as well.
i used a bit of glue stick it to the pad of my finger and ran along the stove, kettle, toaster, etc and i can feel it even without being inside my finger, pretty cool stuff, cant wait now !
just wanna know if what i have here is correct to prepare for the install.
1. throw them in some saline solution for a few days and see if bubbles develop on the surface to verify integrity of the coating.
2. sterilize with (insert here)
3. install?
i wasnt sure if alcohol is sufficient, im guessing ill need something else as well.
i used a bit of glue stick it to the pad of my finger and ran along the stove, kettle, toaster, etc and i can feel it even without being inside my finger, pretty cool stuff, cant wait now !
Tagged:
Comments