It looks like you're new here. If you want to get involved, click one of these buttons!
I have ordered some 1/16 x 1/4 inch NIB cylinder magnets, but they do not have a protective coating. I am looking at the possibility of encasing them in bioglass, but if that does not work out I will probably be investigating some other type of coating. Does anyone have advice on how to coat these to make them safe for injection? The last thing I want is to have to pull a disintegrated magnet out of my body and I have done enough research to know that some type of coating would be required.
If I am unable to coat/encapsulate these properly at home, I am open to suggestions regarding having this done by someone. Since 1/16 inch is smaller than 2mm, I should be able to use a pet injector to implant this.