DIY flex NFC for much cheaper (Please don't call it a flexNT even if it is a flexible nfc implant )

edited April 2017 in RFID/NFC
So I have been doing a lot with the flex pcb things lately for another project related to bio hacking, but as a part of that project I am using super small, super thin nfc chips.

Things to know:
- the larger the antenna the better the read range
- the ones I am showing you you'll still have to coat your self!
- none of this is "safe" but I like to grind in a very DIY way, I know I'm crazy

- here are 6 of them at about $2 per chip. 
You can take these are really make them smaller by cutting the extra parts off the edges as long as you don't cut the copper antenna 
- these ones are a little bit larger, so better range for sure
- this one also has extra pads on the antenna so you can add a different chip to it if you want (does work if you put an iclass chip on it)

Extra info:
- So both of these keep the nfc chip part on the antenna with this black glue stuff, very common, works fine, but it is thermal glue if you want to take the chip off and put your own chip on the antenna (like the iclass chip) you can just heat it up with the soldering iron and it will just come off, don't try and scratch it off because you will break the antenna if you try to.

- take the antenna (whatever one you want)
- cut down the sharp corners and extra material.
- coat the damn thing already
- I use FDA16 and FDA2T both work fine for me but the 16 does seem to go more thin and thats nice.
- this 2.5ml is way more than needed to coat like 20 of these tiny things
- coat them all as a sheet of the whole thing and then cut them out of the sheet of medically coated devices
- again clean up the sharp edges
- implant that shit! or don't, please for the love of god don't do this and blame me if your body doesn't like it


  • Ben, the ones you sent look great to me. I'll get some pics under the scope for you. Do you feel these are safe to impl a nt?
  • edited May 2017
    @Benbeezy Well, I have to admit I am quite impressed. The coating job especially looks pretty great (I really need to start looking into coating techniques). 

    If these do well through fouling tests and whatnot, I'd definitely place an order for a few were you to open for sales.

    All the best.
  • @cassox I think they should be, but really I just had extra resin so I thought I'd give it a shot. on those I didn't look at the coating I just thought I'd sent them along so you can look at them and if anyone wanted to risk it they could be the first. I'm sure the surface looks a little bit weird since I used wax paper to compress the coating to prevent the surface tension from making it dome up make it thicker than needed.

    @trybalwolf Thanks :) I'm going to be putting one in here in the new few days I think and we will see how to holds up, if it's anything like the magnets I've made coated in the same stuff then I'm optimistic. I'm not sure If I will sell them as I don't want to promise things are safe without being any kind of registered in saying so. But I might do a small batch for those willing to take the risk.
Sign In or Register to comment.